Ediz. 005 - 09/2015
www.larius.eu
DALì LINER PLUS
16
H6
3/4
ADJUSTING PUMP UNIT SPEED
• Move the motor acceleration lever (
H5) gently to increase
or decrease the speed of the pump.
During the painting operation it is normally recommended to
maintain the position of the accelerator lever (
H5) at about 3/4
of its maximum run.
PAINTING OPERATIONES
After having performed all of the operations in the
“OPERATION”
chapter, work may be started using the following controls:
• Turn the pressure adjustment handle (
I1) clockwise to allow
the line-painting gun to dispense paint when the appropriate
lever is activated.
I
I2
NEVER point the spray gun at yourselves or at
other people. The contact with the casting can
use serious injuries. In case of injuries caused by
the gun casting, seek immediate medical advice
specifying the type of the product injected.
• An irregular and marked spray on the sides indicates a low
working pressure. On the contrary, a too high pressure causes
a high fog
(“overspray”) and waste of product.
• Pull the lever on the right (
l2) to activate the spray gun and
begin working, advancing the machine in a continuous manner.
Recirculating-safety valve: when working at the
maximum pressure available, releasing the gun
trigger sudden increases of pressure can occur.
In this case, the recirculating-safety valve opens
automatically eliminating part of the product from
the recirculating tube.
Then it closes so as to go back to the first working
conditions.
J2
J3
• Release the residual pressure by holding down the trigger
of the gun and pointing it into a container.
• Eliminate the paint remaining within the tank (
J2) by placing
the re-circulation tube (
J3) into a container.
• Open the recirculating-safety valve (
J4).
J
CLEANING AT THE END OF WORK
• Reduce pressure to the minimum
(turn counterclockwise the
pressure control knob (J1) ).
J4
I1
J1
Summary of Contents for DALI LINER PLUS HAND PUSH
Page 2: ......
