EXTERNAL SPEAKER SETUP
Step 1:
When you use external 8 ohm speaker, connect its cable wire to the 8 OHM SPKR 2-pin Spring Clamp connector (#21), as
the following pin connections. To plug a cable wire into the 2-pin spring clamp connector, push and hold an orange-colored
wire-release latch on the top of the connector, then put a cable wire into its applicable pin and release a wire-release latch.
Figure 3-17. 8 OHM SPKR 2-pin Spring Clamp connector
Step 2:
To adjust the speaker volume, under the MAIN menu of
the Base Station‟s front panel display, move to and select VOLUME.
Then the VOLUME menu appears.
Under the VOLUME menu, move to and select SPEAKER will lead you to volume values. You can change values by UP or
DOWN button.
VOLUME UP ADJUSTMENT
Every time you press and release
the volume up button, a beep will be heard from the external speaker as increased
volume
.
If you press and hold the volume up button, repeating beeps will be heard until the steps up to maximum
.
When
maximum volume is reached, “maximum” will be heard from the external speaker until you release the volume up button
.
VOLUME DOWN ADJUSTMENT
Every time you press and release of the volume down button, a beep will be heard from the external speaker as decreased
volume. If you press and hold the volume down button, repeating beeps will be heard until the steps down to
minimum.
W
hen minimum volume is reached, “minimum” will be heard from the external speaker
until you release the volume down
button.
NOTE:
Either a headset speaker or an external speaker can be used; The SPEAKER volume is for adjusting the volume of
both a headset speaker and an external 8 ohm speaker.
Pin 1: Audio +
Pin 2: Audio -
Pin 1
Pin 2
27