PARING FOR REPLACEMENT
When you pair up a new Belt Pack (
„BP002‟) to replace one („BP001‟) that is already in paired mode, turn off the
„BP001‟ and execute the paring processing with „BP002”. The „BP001‟ can be in use with another Belt Pack Label and
ID after executing the paring up processing again.
NOTE:
If a Belt Pack Label (ID) is duplicated, communication error may occur.
RESET BELT PACK LABELS, COMMUNICATION GROUP, PAIRING
In RESET menu under the BELTPACK menu, you can reset all the present pairing data of Belt Pack Labels and or
Communication Groups to the factory defaults. While processing resets on the Base Station and until the paring
processing is completed again, the applicable Belt Pack is not able to communicate.
RESET BELT PACK LABELS AND COMMUNICATION GROUP
Move to „LABEL‟ or „GROUP‟ and press SET button. The display shows “Yes No”, then move to “Yes” or “No” with
RIGHT or LEFT button and select.
If you go to QUIT and press SET button, you can go back to BELTPACK menu.
Move to „LABEL‟ and select “Yes” then, all existing Belt Pack Labels will be set back to the factory defaults to „_P001‟
through „_P032‟. When you select „GROUP‟ and “Yes”, all the existing setups for Communication Groups will be reset
to the factory default and all the paring icons are changed to ( ).
NOTE:
Pairing process should be applied after reset to communicate with the Belt Packs.
RESET PARING
If
you select “PAIR” in the RESET menu and “Yes”, existing Belt Packs‟ pairings with the Base Station will be lost.
Under the BELTPACK menu, the maximum number of Belt Packs (BPK#), Belt Pack Labels and Communication
Groups are also changed to factory default. And AES code of the Base Station should be changed to another next one
within the three AES codes.
NOTE:
While reset pairing, all connections to Belt Packs will be off. After reset pairing, pairing processing should be
applied to all Belt Packs again.
Figure 3-10.
RESET menu
Pairing …
Pair- ID:000
PairingFailed
Figure 3-9 : Pairing failed status
23