ⓒ
2019
LaON
Technology Co., Ltd. All rights reserved.
33
Beltpack
Beltpack Talk LED does not turn on green and
‘out of coverage’ is heard in the headset.
⚫
Confirm that the POWER switch is turned on and ensure that the battery is fully charged.
⚫
Reboot the Beltpack and Mobiel Station again.
⚫
Check out the coverage. You may be too far from the Mobile Station. The coverage can be varied
depending on the site environments and basically the ‘line-of-sight’ should be secured between the
Mobile Station and Beltpack.
Communication is unable with single or multiple group channels
⚫
Confirm Talk button and light of the Mobile Station and Beltpack
⚫
Check out if the correct communication group channel is selected
⚫
In case a Beltpack in the Master Beltpack mode, communication is available in group #1 only
Communication or pairing is unable between the Mobile Station and Beltpack
⚫
Confirm with the power toggle switch of the Mobile Station if the power is on
⚫
Make sure the two (2) antennas are properly and firmly connected to the Mobile Station
⚫
Make sure the headset is firmly connected to the Beltpack
⚫
Check out if the pairing is made between the Mobile Station and Beltpack
Audio breakups in the coverage
If the Beltpack is near the Mobile Station however the RSSI level is low
⚫
In case of low battery
If the battery level is low, Talk LED of the Beltpack is changed to red. In case of low battery, it may
cause a malfunction. Replace the battery immediately with a fully charged battery or turn off the
Beltpack. In case of low battery, the TX and power is automatically off however continuous using or
pressing Talk button of the Beltpack and etc may cause bad affection to the wireless communications
for a while.
⚫
Ensure that the antennas are properly connected and tightened on the Mobile Station.
