Lantronix WiPort NR, User Manual

Page: 45 / 72

5: Configuration via Serial Mode or Telnet Port
WiPort® NR Embedded Device Server User Guide 45
Show IP Address After RING
Show IP addr after ‘RING’ <Y> ?
Disable or enable the WiPort unit's ability to show the IP address after RING in
Modem Mode. The default is Y (Yes) (shows the IP address).
Auto Increment Source Port
Auto increment source port (N) ? _
Y (Yes) auto increment the source port. The WiPort NR embedded device server
increments the port number used with each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : (000) (000) (000) (000)_
Note: This option is not displayed when Hostlist is enabled from the
ConnectMode
prompt (see page 37 for more information).
Remote Port
Set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is
attempted.
Remote Port (0) ? _
To connect an ASCII terminal to a host using the unit for login purposes, use the
remote port number 23 (Internet standard port number for Telnet services).
Note:
This option is not displayed when Hostlist is enabled from the
ConnectMode prompt (see page 37 for more information).
DisConnMode
Disconnect Mode (DisConnMode) determines the conditions under which the unit will
cause a network connection to terminate. The current value is displayed in
parentheses.
DisConnMode (00) ? _
In DisConnMode, modem_control_in either drops the connection or is ignored. The
following table displays the available input options:
Table 5-12. Disconnect Mode Options
Disconnect Mode Option 7 6 5 4 3 2 1 0
Disconnect with
modem_control_in drop
(6)
1
Ignore modem_control_in 0
Telnet mode and terminal type
setup
(1)
1
Channel (port) password
(2)
1