Lantronix
SDSTX3110-124-LRT-B User Guide
33686 Rev. C
16
3.4 Wiring
3.4.1 Grounding
Grounding and wire routing help limit the effects of noise due to electromagnetic interference (EMI). Run the
ground connection from the ground pin on the power module to the grounding surface prior to connecting devices.
3.4.2 Redundant Power Inputs
The device has two sets of DC power inputs on the 4-pin terminal block located on top of the device. Follow the
steps below to wire the power input on the terminal block.
1. Insert the Terminal Block connector into the keyed receptacle on the SDS.
2. Insert the negative/positive wires into the
V-
and
V+
terminals, respectively.
3. To keep the wires from pulling loose, use a small flat-blade screwdriver to tighten the wire-clamp screws on
the front of the terminal block connector.
