Lansinoh Wearable, Quick Start Manual

Page: 10 / 34

6
6. After Pumping
1. When you finish the session, press and hold the
power button until the pump turns off.
2. Carefully remove the pump from your bra. Keep
the pump upright and carefully remove the pump
hub from the Pumping Cup.
3. Place the Pumping Cup on a clean, stable surface
with the breast flange facing up.
Transferring milk
Use the pour spout to transfer breastmilk to a bottle
or a milk storage bag. Pour the breastmilk carefully
into the selected storage container.
7. Cleaning After Each Use
Disassemble the Pumping Cups.
DO NOT
wash the pump hub. It should be kept dry and never
be rinsed or submerged in water. Wipe down the pump hub, the keypad, and the surface the
pump was placed on with a low-level disinfectant such as Ethyl or Isopropyl alcohol (70-90%).
1. Rinse all the pumping cup parts with cold water immediately after each use. Place the parts
in a clean wash basin used only for washing infant feeding equipment. Do not place the parts
directly in the sink, because germs in sinks or drains could contaminate the parts.
2. Hand wash the parts using warm soapy water. A nipple brush may be used to scrub the hard
plastic parts.
3. Rinse the parts with running clean, warm water, or by submerging in fresh water in a separate
basin that is used only for cleaning infant feeding items.
4. Place the parts on a clean, unused dish towel or paper towel in an area protected from dirt
and dust. Do not use a dish towel to rub or pat items dry. Allow the parts to dry completely
before assembly and use. Partially dried parts may affect the operation of the pump or could
cause deterioration of the components. Once the parts are dry, they can be stored in a clean
plastic bin with a lid or in a clean plastic zipper bag. Do not store the parts in a container or a
bag until fully dry.
5. Clean the wash basin and the nipple brush after each use following the manufacturers
recommendation for cleaning. Rinse them well and allow them to air-dry after each use.
See Cleaning and Disinfecting steps in Section 2.