Lanner HTCA-6400, User Manual, Page: 25 / 101

Chapter 3: Hardware Setup
25
3. For the other end of the carrier, align
the alignment feature of the processor
with the carrier latch, and then gently
bend over the carrier end to have the
latch secured on the processor.
4. Align PIN1 of the processor with the
corner cutout of the heat sink (if there are
two corner cutouts on one heat sink,
either will do).
5. With a little pressure, push the four
corners of the carrier down to engage
their latching features with the
corresponding corners of the heat sink.
You might hear a clicking sound when the
latch clicks into place.
6. Inspect the four corners to make sure
the latches are all engaged. If correctly
latched, the corners of the carrier should
be tightly attached to the heat sink, with
no gap in-between observed.
Cutout
5
6
Unlatched
4
3
Latch