Langer & Laumann TSG Sinus Drive, Installation Instruction

Page: 5 / 27

5 / 27
2 General safety requirements
The TSG Sinus Drive is designed exclusively for the automatic operation of locks on sliding doors. For appli-
cations that fall outside the defined application, the manufacturer accepts no liability. The TSG Sinus Drive
contains dangerous voltages and controls moving mechanical parts. Failure to follow the instructions in this
manual can result in death, severe personal injury or substantial property damage.
The TSG Sinus Drive is built according to the state of the art and recognised safety engineering rules and is
intended exclusively for normal industrial usage. If it is used for any other purpose, the manufacturer must in
every case be consulted. Otherwise no liability is assumed for personal injury or property damage. Any other
or more extensive use is considered contrary to designated use and may result in personal injury for the user
or third parties as well as damage to property.
WARNING:
When electrical devices are in operation, certain parts of the devices conduct dangerous volt-
age. Failure to observe the operating instructions may therefore result in serious bodily inju-
ries or property damage! Observance of the warning notices in these operating instructions is
absolutely mandatory. While the TSG is starting up, door movements cannot always be con-
trolled externally. During commissioning, an authorised person located at the door must ensure that no other
persons can reach the area close to the door. Permissible forces and energy levels must be checked by a
qualified person after the door has been commissioned.
2.1 Delivery
Using the delivery note and the operating instructions, check the delivered components to ensure complete-
ness. At the same time perform a visual inspection for damage of delivered materials. While unpacking,
check:
Whether there is any visible mechanical damage to components.
Whether the lengths of the cables included with delivery are correct.
CAUTION:
Electrostatic discharge, mechanical load, moisture and dirt will damage or destroy electronic
components.
Leave electronic components in their original packages until they are installed.
If damage occurred during shipping, a claim must be filed immediately with the shipping company.
If components are missing, inform the supplier immediately.