Langer & Laumann TSG Sinus Drive, Installation Instruction

Page: 10 / 27

10 / 27
5 Description
The TSG Sinus Drive performs a linear movement, which can be used to actuate a lock or cam lock on an
elevator car. It is controlled via the TSG electronics. The stroke is adjustable between 20, 30, 45 or 60 [mm].
The TSG expansion board can control and process up to two additional drives and is connected to the con-
trol part of the TSG motherboard. In the TSG motherboard parameters of the drive and the time delay be-
tween the opening of the drive and open the door (hC) can be set to activate the feature (hA), the Open time
(h7), the closing time (hb).
5.1 Activating the function
The function to use the TSG expansion board can drive, the parameter hA must be set accordingly. This is
only possible with optional add-on board stocked.
hA = 01: control TSG Sinus Drive (us-able with add on board TSG Si-nus Drive)
hA = 03: control TSG Sinus Drive with emergency power supply (usable with add on board TSG Sinus Drive)
hA = 06: control TSG Sinus Drive for shaft hinged doors (usable with add on board TSG Sinus Drive)
hA = 16: CANopenLift- or ThyssenFx -Bus-communication and TSG Sinus Drive (usable with add on board
CAN and TSG Sinus Drive)
hA = 17: CANopenLift- or ThyssenFx -Bus-communication and TSG Sinus Drive with emergency pow-er
supply (usable with add on board CAN and TSG Sinus Drive)
hA = 18: CANopenLift- or ThyssenFx -Bus-communication and TSG Sinus Drive for shaft hinged doors (usa-
ble with add on board CAN and TSG Sinus Drive)
* (valid from version TSG V4, 4.60.12)
CAUTION:
The setting hA = 02, 04 or 05 is not suitable for this application.
.
NOTE:
Is ha = 00, the TSG Sinus Drive is not actuated.
NOTE:
For more information on parameter setting see also the manual door control unit TSG.