Langer & Laumann TSG Sinus Drive, Installation Instruction

Page: 13 / 27

13 / 27
5.3 Open and closing time
The open and the closing time of the TSG Sinus Drive can be set via the parameter h7 and hb.
The values can be changed in 0.01 second increments. The default value can be assumed for both the input
and for the exit of the drive for a time of 0.50 seconds. However, this value must be controlled and must be
adapted according to local circumstances.
Tabelle 1 Screw for stroke adjustment:
adjusted stroke of
Max load
parameter h7
(Opening time of the
skate)
parameter hb
(Closing time of the
skate)
ca.60mm 2,3kg 53 46
ca.45mm 3,1kg 54 45
ca.30mm 4,6kg 55 45
ca.20mm 7,0kg 54 46
CAUTION:
The values must not be set greater than the time that is really needed to drive on and extend.
Otherwise it can cause failure of the drive!
NOTE:
If a value is changed and confirmed, the value is stored permanently, ie even after a power
failure, the changed value is available again.
NOTE:
For more information on parameter setting see also the manual door control unit TSG.
5.4 Time delay between door drive and TSG Sinus Drive
It is possible to set that in an open command from the elevator control system to the door control device TSG
first drive the TSG Sinus Drive apart and then ascends the door. For this purpose, the parameter hC can be
adjusted. The value can be varied in 0.01 second increments.
NOTE:
For more information on parameter setting see also the manual door control unit TSG.