CART
A
HOIST
™
GEN. 2
®
Special Instructions:
Unlock the position pin (set screw) by pulling it out and turning it 1/4 turn (Fig. 4). Slide the foam
pieces about 1/4 way in on either side of the bar HAC-062 then slide HAC-064 on one side of the bar and HAC-063 on the
other side of the bar. You may have to back out the larger set screw a little. Push the HAC-063 assembly all the way into the
bar then back it off approximately an inch, then tighten the large set screw with the Allen key to secure in place. Put the
other side (HAC-064) on the bar, but leave the set screw loose. Put the cradle on the base of the platform as show in (Fig. 2).
Push the parts HAC-064 so that the bearing wheels align on top of the bars and tighten the larger set screw in place. The
smaller set screws should be set so that they just barely touch the bars HAC-060 and HAC--061 (Fig. 3) and should allow the
assembled cradle bar to roll/slide freely.
STEP 9
Locate parts
: HAC-063, HAC-064, HAC-062, HAT-018 QTY: 2,
Locate hardware:
Set screws should come pre-installed. If one or more is not there check packaging or call Lange Originals
cradle bar assembly
HAT-018
HAT-018
HAC-062
Set Screws (Preinstalled)
Set Screws (Preinstalled)
Set Screws (Preinstalled)
Set Screws (Preinstalled)
HAC-063
HAC-063
HAC-064
HAC-064
Fig 1
Fig 2
Page 10
