Lang R60S-ATA, Installation And Operation Instructions Manual

Page: 6 / 20

Installation
Receiving the Range
Upon receipt, check for freight damage, both visible and concealed. Visible damage
should be noted on the freight bill at the time of delivery and signed by the carrier’s agent.
Concealed loss or damage means loss or damage, which does not become apparent until
the merchandise has been unpacked. If concealed loss or damage is discovered upon
unpacking, make a written request for inspection by the carrier’s agent within 15 days
of delivery. All packing material should be kept for inspection. Do not return damaged
merchandise to Lang Manufacturing Company. File your claim with the carrier.
Location
Prior to un-crating, move the range as near its intended location as practical. The crating will help protect the unit
from the physical damage normally associated with moving it through hallways and doorways.
Un-crating
The range will arrive completely assembled inside a wood frame covered by cardboard box and strapped to a skid.
Remove the cardboard cover, cut the straps and remove the wood frame.
RANGE WEIGHS AROUND 900 LBS (408 kilograms). FOR SAFE HANDLING,
INSTALLER SHOULD OBTAIN HELP AS NEEDED, OR EMPLOY APPROPRIATE
MATERIALS HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY, OR PALLET
JACK) TO REMOVE THE UNIT FROM THE SKID AND MOVE IT TO THE PLACE OF
INSTALLATION.
ANY STAND, COUNTER OR OTHER DEVICE ON WHICH RANGE WILL BE
LOCATED MUST BE DESIGNED TO SUPPORT THE WEIGHT OF THE OVEN (900
LBS.).
SHIPPING STRAPS ARE UNDER TENSION AND CAN SNAP BACK WHEN CUT.
Remove range from skid and place in intended location.
Installing the Legs
Legs or casters are available and must be specified upon ordering.
To install the 6-inch legs, remove the legs from the oven cavity. Using a floor jack, raise one end of the unit at a time,
fasten the legs into the threaded holes provided. Low the completed side and repeat process on the opposite side.
To install the 6-inch casters, remove the casters from the oven cavity, Using a floor jack, raise one end of the unit at a
time. Attach the casters to the adapter plates. Low the completed side and repeat process on the opposite side.
CAUTION
CAUTION
CAUTION