![background image](http://html1.mh-extra.com/html/lang/lgr36-nfr/lgr36-nfr_owners-manual_674600014.webp)
I
NSTALLATION
I
NFRARED
C
OMPACT
B
ROILER
P
AGE
14
OF
24
O
WNER
’
S
M
ANUAL
1192039
(10/09)
S
TEP
2
C
:
A
TTACH
C
OUNTERTOP
L
EGS
1. Install each leg by screwing them into the threaded holes in the bottom of the base.
2. Stand the broiler on its legs and position to minimum clearances specified on serial tag.
Figure 6
Attaching Legs for Countertop Infrared Compact Broiler
S
TEP
3:
C
ONNECT
G
AS
S
UPPLY
If this equipment is being installed at over 2,000 feet altitude and that information was not specified when ordered,
contact the appropriate authorized Lang Service Representative or the Lang Service Department. Failure to install
with proper orifice sizing will result in poor performance and may void the warranty.
The broiler is design-certified for operation on natural or propane gases. The broiler is shipped configured and
adjusted for the type of gas specified by the purchaser, which is indicated on the serial plate (see Figure 1 on page 3).
Connect the broiler ONLY to the type of gas for which it is configured and adjusted.
The Infrared Compact Broiler mounts on the flue riser of a range, and either will have a 3/8" rear gas connection (with
a 3/8" male NPT connector) extending through the rear of the flue riser (see Figure 2 on page 5), or will have the
optional internal-piping to the front-manifold of the range.
For wall-mount and countertop models, the gas connection (3/8 NPT) extends directly out the rear of the broiler (near
the bottom-right-rear corner), or (using an elbow) out the top of the broiler near the top-right-rear corner.
Minimum supply pressure is 7" W.C. for natural gas, 11" W.C. for propane. An internal pressure regulator and shutoff
valve are provided. If using a flexible-hose gas connection, the I.D. of the hose must not be smaller than the
connector on the broiler, and must comply with ANSI Z21.69. Provide an adequate means of restraint to prevent
undue strain on the gas connection.
If applicable, the vent line from the gas appliance pressure regulator must be installed to the outdoors in accordance
with local codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1, Natural Gas
Installation Code, CAN/CGA-B149.1,
or the
Propane Installation Code CAN/CGA-B149.2,
as applicable.
An adequate gas supply is imperative. Undersized or low-pressure lines will restrict the volume of gas required for
satisfactory performance. A 1/8" pressure tap is located on the manifold to measure the manifold pressure. The
supply line to the broiler should be no smaller than the inside diameter of the pipe on the broiler to which it is
connected.