![background image](http://html1.mh-extra.com/html/lang/ecsf-es/ecsf-es_installation-and-operation-instructions-manual_3591753015.webp)
5
Enviro-ZONE
Initial Power On Test:
1)
Energize Oven and verify the basic operation and temperature control capability of oven.
a.
Turn Power On. Verify interior lights and the display comes on. _____
b.
Install a Temperature Meter thermocouple in center of oven cavity.
c.
Using ‘Run Oven’ / ‘Manual Program’, set temperature to 300°F. _____
d.
Verify oven reaches set point & signals ‘Ready’ with an audible tone with in
12 Minutes. (starting with a cold oven) _____
e.
Press Manual Program again. Using the enter key and up button, enter time 00:0:00,
Press ‘Accept’ and then select shelf “C”. Verify the shelf timer starts count down;
Verify the fan stops and reverses direction after approximately 08 seconds.
(complete reversing cycle takes 2 minutes.) _____
f. V
erify the measured temperature at the transition point (when heat contactor changes
states.) matches the temperature on the display panel. _____
g.
Open door and verify the Fan stops then restarts when door is closed. _____
h.
Press Cancel several times to return to “Run Oven” menu.
i.
Confirm fan stays on until temp cools to below approximately 250°F. _____
For units with water hookup for Steam.
2)
Identify water purification system used: _________________________________________
(write “none” if no water treatment system is in use.)
3)
Flush water system to clear tainted water from the install process. _____.
a.
Put oven into Back-Up Mode and set temperature to approx. 400°F.
b.
Once up to temp, Use the steam bypass switch (spring loaded toggle switch) to
flush the water through the oven for 1 minute.
c.
Check water drain for proper operation.