![background image](http://html1.mh-extra.com/html/lang/ecoq-ap-wb/ecoq-ap-wb_installation-operation-maintenance-and-troubleshooting_3589753008.webp)
9
6. INITIAL START UP
5.1 PRE-POWER ON
After the oven is installed and connected to power, prior to turning on, verify the
following:
•
The door open and closes freely.
•
All three racks are in the oven correctly
•
All packing materials have been removed from the inside of the oven.
5.2 POWER ON
When the oven is first turned on the display will read “Enter”. The oven will not
begin to heat up at this point. As soon as a product button is pressed, (buttons
numbered 1 through 10), the oven begins to heat to the bake temperature for the
product selected. During this time the display will read “Preheat”. When the oven
reaches the correct temperature for the product selected, the display will read
“Ready”.
If the oven came pre-programmed from the factory, a light will be on next to each
product number which is programmed. Any of the products with the light on can be
selected. After selecting a product button the oven will preheat. Once the oven has
reached it’s programmed temperature, the product button will flash along with all of
the product programs with the same programming temperature. Now select the
product you would like to cook, and then select the shelf that the product was loaded
onto, to begin the cooking cycle.
If there are no product button lights on, it will be necessary to program your products
before the oven will operate. See section 6 Operation, on page 8 of this manual to
learn about programming the oven.
NOTICE
During the first few hours of operation you may notice a small amount of smoke
coming off the oven, and a faint odor from the smoke. This is normal for a new
oven and will disappear after the first few hours of use.