8
INSTALLATION cont.
Leg Pad Adapter
Identify the front and rear leg adapters (the
front adapters have two threaded inserts, the
rear has four). The leg adapters are included
with each specific accessory kit.
Leg to Adapter Installation:
Install the leg’s threaded stud through the hole
in the adapter labeled “C” with the bent flange
of the adapter facing away from the leg.
Screw the 3/4-inch nut supplied in the
adapter kit onto the leg stud and tighten.
Secure to oven using hardware provided.
Caster to Adapter Installation:
Place the swivel caster against the front leg
pad adapter with the flange of the adapter
facing away from the caster.
Install the four 5/6 inch bolts through the
caster base and the adapter holes labeled “A”
then install the 5/6 inch nuts with washer and
lock washers.
Place the rigid casters against the rear leg
adapter with the flange of the adapter facing
away from the caster.
Align the caster to the holes in the adapter
labeled “B”. NOTE: There are two sets of “B”
holes set at 90° from the each other. One set
will create a left rear adapter and the other set will create a right rear adapter.
Install four 5/16-inch bolts through the caster base and the adapter holes labeled “B” then install
5/16-inch nuts with lock washers and flat washers.
Adapter to Oven Installation:
Gently tip the oven onto its left side. Place the front leg adapter into the front corers of the oven.
The holes without the threaded inserts face the front of the oven and the flange on the adapter
points toward the bottom of the oven.
The edge of the leg adapter with the threaded insert slips under the flange on the oven side, while
the edge without the inserts sits on top of the threaded angle on the oven front.
Install two 3/8-inch bolts with lock washers and flat washers through the front holes “D” in the leg
adapter and into the threaded inserts on the oven.
Thread one 3/8-inch bolt with lock washer and flat washer into the rear threaded hole labeled “E” on
each of the leg adapters.
The forward threaded hole on the front leg adapter does not get a bolt installed.
Place the rear leg adapters into the rear corners of the oven so that the adapter is under the flange
of the oven side and back.
NOTE:
If installing a caster place the adapter on the oven so that the casters roll forward.
Install for 3/8-inch bolts with lock washers and flat washers through the holes labeled “E” in the
flange of the oven and into the threaded inserts of the leg adapter.
FRONT
BOTTOM
A
A
A
A
C
C
D
E
IL2234
E
E
E
E
E
E
B
E
E
E
D
D
D
C
C
B
Above: Bottom on unit showing the placement of the leg adapters
and their hole assignment.
