Lang ECCO-AP, Service Manual

Page: 31 / 73

30
TYPICAL OPERATION CONT’D
ECCO-PP TYPICAL OPERATION SEQUENCE
ACTION RESULT
Turn power switch to ON. Control panel comes on, display says “SELECT
PRODUCT OR READ/CLEAR TO PROGRAM
.
Press a product button. Display says “PRODUCT X PREHEATING TO
XXX F”. Motor starts and oven begins preheating
to the programmed temperature.
Beeper sounds briefly. Display says “READY SELECT PRODUCT TO
START ” .
Open the oven doors and load the product. Close
the door and press the product button again. Beeper sounds briefly and display says
“SELECT
OVEN SHELVES PRODUCT X” .
Press the shelf button(s) which correspond to the
shelf positions just left, which the product is loaded
(A equals the top shelf and E equals the bottom
shelf). Display shows a countdown timer and begins to
count toward zero.
Beeper sounds continuously. Display shows “DONE PRESS SHELF BUTTON
X, REMOVE PRODUCT” , shelf button(s) flash.
Press the flashing shelf button(s). Beeper stops. Display shows “ READY SELECT
PRODUCT TO START ” if no other shelves carry
product or resume count down for shelves that still
have product cooking.
Open oven door and remove the product, which
corresponds to flashing shelf button(s).
ECCO-SII TYPICAL OPERATION SEQUENCE
ACTION RESULT
Turn power switch to ON. Digital display reads “
000
”
”.
Press Temp button and use arrows to adjust to
proper Temp between 150 & 450. Oven begins heating and displays “
pre
”.
Beeper will sound for 3 seconds when preheated.
Open doors and insert product.
Display will read preheated temperature.
Press Time Button and use arrows to adjust to
desired time. Press Start / Stop Button. Digital display will start countdown.
Beeper sounds continuously Press Start / Stop
Button.