Landoll Till 'N Seed BPS6, Operator'S Manual

Page: 22 / 58

2-8 3P091
OPERATION

CAUTION
NOTE
Front Seedbox Seed Cups discharge to the front of the
machine.
• All cups must be set the same to seed uniformly.
Check by using the wrenches provided and loosening
the Inner Adjusting Nut and turning the Outer Seed
Rate Adjusting Nut so that the Seed Cups close.
• All cups should be completely closed. If not, individual
cups can be adjusted by loosening their mounting
bolts, moving the cups, and then re-tightening.
• With Seed Cups completely closed, Indicator edge
marked "0" should align with Seed Cup Cut-off end. If
it does not, loosen Indicator mounting hardware and
adjust it until it does. Re-tighten.
• The second Seed Cup from each end has a decal
scale applied to assist in determining how far open the
meter is.
• Use Seed Chart located inside Seedbox Cover as a
guide, increase or decrease the Seed Rate by using
the wrenches provided and loosening the Inner
Adjusting Nut and turning the Outer Seed Rate
Adjusting Nut to the desired number setting on
Indicator. Re-tighten the Inner Nut.
Figure 2-8: Front Seedbox Cups
To prevent damage to seed meters, do not apply
excessive force to adjusting nuts. This is
especially important when closing meters as
seed in flutes can be pinched between seed cup
cutoff and washer.
Do not close meters more than 1/8" when there is
seed in the meters without rotating the seed shaft
to prevent damage to the rotating washers and
retainer rings in the seed meters.
Do not attempt to open meters more than 1".
(feed rolls could become disengaged from the
seed cup washer.)
6KDIWPRYHVWRLQFUHDVHVHHGUDWH
6KDIWPRYHVWRGHFUHDVHVHHGUDWH
:UHQFKHV
2XWHU6HHG5DWH
$GMXVWLQJ1XW
,QQHU6HHG5DWH
$GMXVWLQJ1XW
6HHG&XS0RXQWLQJ
+DUGZDUH
,QGLFDWRU
/DUJH
6HHG&XS
6HHG&XS
&XWRII
,QGLFDWRU0RXQWLQJ
+DUGZDUH
,QGLFDWRU6FDOH
,QGLFDWRUPXVWUHDG
ZKHQ6HHG&XSVDUHFORVHG