Landoll Brilllion Till'N Seed BPSB-8, Operator'S Manual

Page: 46 / 76

3-14 F-1097-2305
OPERATION
TABLE OF CONTENTS
Agitator Box Calibration for
Unlisted Seeds
NOTE
Calibration Crank Assembly used for Calibration is stored
in the toolbox.
Brillion assumes no liability pertaining to Seeding Rates
achieved with this Seeder. Rates listed are general in
nature and should be used as starting points only. Seed
varieties and blends listed represent those calibrated
through in-house test meters.
Variations in actual rates may be realized due to
differences in seed lots. For accurate rates with seeds
being used, follow the calibration instructions listed on
the Seed Chart inside the Seed Box Cover or refer to this
manual.
See Figure 3-28. The information listed in the
Seed Chart is subject to change without notice.
Calibrate Unlisted Seeds as follows:
1. Agitator Shaft turns 456 revolutions per acre seeded.
2. Raise machine and lock in Transport Position.
3. Place Calibration Tray in collection positions to catch
seed. Remove the 5/16-18 Wing Nuts that secure the
Calibration Tray Cover over the opening in the
Agitator Box RH Support Plate.
See Figure 3-24.
Remove the 5/16-18 Wing Nut that secures the
Calibration Tray in the storage position. Orient the
Calibration Tray with Handle to the top and insert it
into the Agitator Box RH Support opening.
See
Figure 3-25.
4. Remove Agitator Drive Pin. See Figure 3-26.
5. Turn Transmission Agitator Shaft Calibration Hex 456
revolutions clockwise (CW) with provided Crank. 76
turns may be used if results are adjusted as stated in
Step 6.
6. Weigh seed for approximate planting rate in lbs/acre.
Multiply weight by 6, if only 76 turns were used.
7. Install Agitator Drive Pin.
8. Place Calibration Tray back in storage position.
Secure with 5/16-18 Wing Nut. See Figure 3-27.
Re-install Calibration Opening Cover over the
opening in the Agitator Box RH Support Plate with
5/16-18 Wing Nuts.
Figure 3-24: Calibration Opening Cover - Agitator
Box
Figure 3-25: Calibration Tray Collection Position -
Agitator Box
Figure 3-26: Agitator Box Calibration
Agitator Box
RH Support Plate
Calibration
Opening Cover
Wing Nut,
5/16-18
Agitator Box
RH Support
Plate Calibration
Tray Opening
Agitator Box
RH Support Plate
Calibration Tray
34 Tooth
23 Tooth
218254
Calibration Crank
Large Meter
Calibration Hex
Idler
Micro-Meter
Calibration Hex
Agitator
Drive Pin