Landoll Brillion XXL184, Operator'S Manual

Page: 36 / 40

Clevis Hitch
Set-Up
Bolt,1-8 x 4-1/2
Bolt,1-8 x 2-3/4
Pin,Cotter
5/16 x 3-1/2
Slotted Nut,1-1/2-6
Safety Chain
Lock Nut,1-8
Drilled Bolt,
1-1/2 x 7
Hitch Lock Up
Channel
Lock Nut,1-8
Flat Washer,1-1/2
Flat Washer,1-1/2
Washer,
1.56 x 3.5 x .75
Washer,1in Narrow
Hitch Lock Kit - Optional
Do Not Remove Hitch to Install
Clevis Hitches:
Remove the Safety Chain and set aside.
Insert the Hitch Lock Up Channel into the Drawbar and line up bolt holes.
Insert 2-3/4” bolt into the righthand hole, thread Lock Nut on. Do Not fully tighten at this time.
Insert 4-1/2” bolt into the lefthand hole, slide four 1in Narrow Flat Washers over the bolt, then
Safety Chain,
thread Lock Nut on. Do Not fully tighten at this time.
Position three 1-1/2 Flat Washers and two 1.56 x 3.5 x .75 Washers between the Hitch Lock Up Channel
and Hitch.
Position one 1-1/2 Flat Washer and one 1.56 x 3.5 x .75 Washer on top of the Hitch.
Insert Drilled Bolt up through the Hitch Lock Up Channel, Washers and Hitch.
Thread Slotted Nut onto Drilled Bolt,
align drilled hole and nut, insert 5/16 x 3 Cotter Pin and spread fully. tighten and
Tighten all hardware.
To adjust angle of hitch, move washers from bottom to top or vice versa.
190rev501 Page 22B 9J698