Landoll BRILLION TURFMAKER II SL, Operator'S Manual

Page: 49 / 100

ASSEMBLY
9K998 2-33
21. Sight along Seed Boxes from ends, front and rear to
ensure Seed Boxes are straight and level, ensure
that all Seed Shafts turn freely and are not binding.
Tighten Double Box Center Bracket and RH Double
Box Support Hardware that attaches the Seed
Boxes. Tighten U-Bolts that mount the Center
Bracket and the RH Support to the Seeder Frame
Tube.
22. Slide the Bearing Carrier Bearing onto the Front
Seed Box Seed Rate Adjusting Screw and attach the
Bearing Carrier to the RH Double Box Support.
23. Install Seed Rate Adjusting Nut onto Front Seed Box
Seed Rate Adjusting Screw.
24. Install Bearing Carrier onto RH Double Box Support
with 5/16-18 x 1-1/4 Bolts, Flat Washers, Lock
Washers and Nuts.
See Figure 2-50.
25. Assemble onto the Rear Seed Box Seed Shaft the
Seed Rate Adjusting Screw, 1-8 Nut, Bearing, Seed
Rate Adjusting Nut and 1/2-13 Locknut.
Place
Bearing between Flangettes and attach to Bearing
Carrier with 5/16-18 x 1 Bolts, Lock Washers and
Nuts.
See Figures 2-49 and 2-50.
Figure 2-49: Rear Box Seed Rate Adjuster
26. Adjust Front and Rear Seed Box Seed Meters so that
all the Seed Meters are closed. Preform Seed Meter
“0” Adjustment in
“Seed Meter Adjustment” on
page 4-8 .
27. Install Front Seed Shaft Coupler and tighten Rear
Seed Box Feed Roll Coupler Assembly Set Screws
against the Seed Shaft and tighten Jam Nuts against
Feed Roll Coupler.
28. Tighten the Transmission #40 Drive Chain Idler
Sprocket Clevis Drawbolt Locknut to apply tension to
the Drive Chain and secure by tightening the Axle
Bolt.
See “Chain Tension” on page 4-6.
29. 8 and 10Ft Seeders, Install RH and LH Light
Brackets.
30. 12Ft Seeders, Install Turnbuckles to Double Box RH
Support, Double Box Center Bracket and LH Double
Box Mounting Plate.
31. Connect Acre Meter and Warning Lamps.
/RFNQXW
6HHG
6KDIW
6HHG5DWH
$GMXVWLQJ1XW
%HDULQJ
/RFNQXW
1XW
$GMXVWLQJ
6FUHZ
6/2S6HHG5DWH$GM5HDU%R[