Landoll BRILLION TURFMAKER II SL, Operator'S Manual

Page: 44 / 100

2-28 9K998
ASSEMBLY
11. Remove the Mount Plate Hardware and slide the LH
Seed Box far enough to the right to remove the
Mount Plate from the Seed Box and Transmission.
Complete removal of the Seed Box is not required,
the Seed Shaft will slide in the 37 Tooth Sprocket
and Bearing. Remove the Single Box Mount Plate
and replace it with a Double Box Mount Plate on the
Transmission and LH Seed Box ensuring that the
Seed Shaft is aligned and free to rotate. Tighten
Hardware.
12. Remove Transmission Shield, Sprocket Cover and
2-Hole Cover from Transmission. See Figure 2-38.
13. Disassemble Hex Bore Bearing from Sprocket Cover
and assemble it onto the outside of Sprocket Cover
Weldment (surface opposite channel). Do not tighten
at this time.
See Figure 2-39. Assemble Idler
Sprocket onto Sprocket Cover Weldment Channel
with 5/8-11 X 2-1/4 Bolt, Flat Washers, 5/8- x 1 x
14ga Washers, Lock Washer and Nut. Do not tighten
at this time. Mount Sprocket Cover Weldment on
Transmission while sliding Hex Bore Bearing onto
Front Seed Shaft. Check Idler Sprocket alignment
with Jackshaft Sprocket and adjust 5/8 x 1 x 14ga
Washers accordingly. Ensure that the Front Seed
Shaft is aligned and free to rotate, tighten Hardware.
Figure 2-38: Transmission Shield
14. Install 3/4 Bearings and Flangettes on Transmission
with 5/16-18 x 1 Bolts, Lock Washers and Nuts. Do
Not Tighten at this time.
Figure 2-39: Rear Box Transmission
7UDQVPLVVLRQ
6KLHOG
&RYHU
6SURFNHW
&RYHU
7UDQVPLVVLRQ
6HHG6KDIW
+H[%RUH
%HDULQJ
5ROO3LQ[
&KDLQ[3LWFKHV
6SURFNHW7RRWK
1XW
/RFN:DVKHU
%HDULQJ
)ODQJHWWH
)ODQJHWWH
'ULYH7XEH
%ROW
[
%ROW[
1XW
/RFN:DVKHU
:DVKHU[
[JD
)ODW:DVKHU
6SURFNHW&RYHU
:HOGPHQW
:DVKHU[
[JD
)ODW:DVKHU
,GOHU6SURFNHW
%ROW
[
6HHG6KDIW
7UDQVPLVVLRQ
'RXEOH%R[
0RXQW3ODWH
%HDULQJ
%HDULQJ
+H[%RUH
6/2S5HDU%R[7UDQ\