Landoll Brillion Turfmaker II Series, Operator'S Manual

Page: 47 / 114

9K998-2306 2-29
TABLE OF CONTENTS
11. Remove the Mount Plate Hardware and slide the LH
Seed Box far enough to the right to remove the Mount
Plate from the Seed Box and Transmission. Complete
removal of the Seed Box is not required, the Seed
Shaft will slide in the 37 Tooth Sprocket and Bearing.
Remove the Single Box Mount Plate and replace it
with a Double Box Mount Plate on the Transmission
and LH Seed Box ensuring that the Seed Shaft is
aligned and free to rotate. Tighten Hardware.
12. Remove Transmission Shield, Sprocket Cover and
2-Hole Cover from Transmission. See Figure 2-46.
13. Disassemble Hex Bore Bearing from Sprocket Cover
and assemble it onto the outside of Sprocket Cover
Weldment (surface opposite channel). Do not tighten
at this time.
See Figure 2-47. Assemble Idler
Sprocket onto Sprocket Cover Weldment Channel
with 5/8-11 X 2-1/4 Bolt, Flat Washers, 5/8 x 1 x 14ga
Washers, Lock Washer and Nut. Do not tighten at this
time. Mount Sprocket Cover Weldment on
Transmission while sliding Hex Bore Bearing onto
Front Seed Shaft. Check Idler Sprocket alignment
with Jackshaft Sprocket and adjust 5/8 x 1 x 14ga
Washers accordingly. Ensure that the Front Seed
Shaft is aligned and free to rotate, tighten Hardware.
Figure 2-46: Transmission Shield
14. Install 3/4 Bearings and Flangettes on Transmission
with 5/16-18 x 1 Bolts, Lock Washers and Nuts. Do
Not Tighten at this time.
Figure 2-47: Rear Box Transmission
Transmission
Shield
Cover
Sprocket
Cover
Transmission
Seed Shaft
Hex Bore
Bearing
Roll Pin,1/4 x 1-1/2
Chain,#40 x 66 Pitches
Sprocket,23Tooth
Nut,
5/16-18 Bearing,3/4
Flangette
Flangette Drive Tube
Bolt,
5/8-11 x 1
Bolt,5/16-18 x 1
Nut,5/8-11
Lock Washer,5/8
Washer,5/8 x 1
x 14ga
Flat Washer,5/8
Sprocket Cover
Weldment
Washer,5/8 x
1 x 14ga
Flat Washer,5/8
Idler Sprocket
Bolt,5/8-11
x 2-1/4
Seed Shaft
Transmission
Double Box
Mount Plate
Bearing,3/4
Bearing,
Hex Bore
SL2 OpRearBoxTrany2020
Jackshaft
Lock Washer,
5/16