Landoll Brillion Turfmaker II Series, Operator'S Manual

Page: 37 / 114

9K998-2306 2-19
TABLE OF CONTENTS
Connector outside the Seed Box, feed the terminals
through the Cord Grip. Install the terminals into the
3-Pin Shroud labeled “A”, “B” and “C” as follows “A”
White, “B” Black, “C” Green.
See Figure 2-28. Inside
the Seed Box, provide enough cord slack to the Bin
Level Sensor Cord to allow for future adjustments of
the Sensor. Secure the Bin Level Cord by tightening
the Cord Grip Compression Nut. Connect both Bin
Level Sensors to the Seeder Harness.
Figure 2-28: Bin Level Sensor Wire Detail
8. Connect the 240" Extension Harness to the Seeder
Harness. Route the 240" Extension Harness along
the Seeder Frame and down the Drawbar/3-PT Hitch
to the Tractor.
9. Install Brillion Elite Mini Monitor on Tractor. See
“Brillion Elite Mini Monitor Tractor Installation -
Optional” on Page 2-23.
10. If not already installed, install Smart Clutch Relay into
Elite Mini Tractor Harness 3-Pin Connectors.
11. Connect the Elite Mini Tractor Harness 14-Pin
Connector to Brillion Elite Mini Monitor, 3-Pin Power
Plug to 12 Volt Tractor Convenience Outlet and 6-Pin
Connector to the 240" Extension Harness. 4-Pin
Connector is not used at this time.
12. Bundle and secure all Harnesses along the Seeder
Frame and Drawbar/3-PT Hitch with Tie Wraps.
13. Program Bin Level Sensors and Smart Shaft Sensors
if not already pre-programmed. See “Brillion Elite
Mini Monitor” on Page 4-1.
Figure 2-29: Front Seed Box Smart Shaft Sensor Detail
Figure 2-30: Rear Seed Box Smart Shaft Sensor Detail
White Wire
Black Wire
Green Wire
Terminal
3-Pin Shroud
Shroud Pin ID
Seal
A
A
Seed Shaft,11/16 Hex
SECTION A-A
1/8" Max
Sensor
Mount
Smart Shaft
Sensor
Magnet Wheel
Assembly
Magnet Wheel Assembly
Sensor Mount
Smart Shaft
Sensor
A
A
Sensor Mount,
4.25 Spacing
Seed Shaft,
3/8 Square
Magnet
SECTION A-A
1/8" Max
Smart Shaft Sensor
Magnet
Magnet Collar
3/8 Sq Shaft
Smart Shaft
Sensor
Sensor Mount,
4.25 Spacing
Magnet
Collar
3/8 Sq Shaft