2-1
Chapter 2
Assembly
CAUTION
The intent of this chapter is to provide instruction,
allowing you to safely and correctly assemble your
Brillion product.
IMPORTANT
If a pre-assembled component or fastener is
temporarily removed, ensure it is correctly
re-installed per these instructions.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
Frame Assembly
NOTE
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
1.
Place frame section on supports approximately 2' off
the floor. See Figure 2-1.
2.
If machine is 12' to 16' in width, bolt center frame
extensions to the ends of the center frame. Use
Grade 5, 5/8-11 x 2" Screws with 5/8" Lockwashers
and Nuts. The 18' and 20’ models utilize a “one
piece” frame and no extensions are required.
Figure 2-1: Frame Assembly
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means!
4” x 6” FRAME
FRAME
EXTENSION
FRAME
EXTENSION
SCREW, 5/8” x 2”
LOCKWASHER, 5/8”
NUT, 5/8”
