F-1049-0421
3-1
Chapter 3
Assembly Instructions
It is very important that your new 2512 Series Rigid or
Folding Zone Commander be properly assembled,
adjusted, and lubricated before use. Illustrations are
provided in this section to show proper assembly
procedures. Remove paint from grease fittings and
replace any that are damaged or missing. Be sure to
return bolts, clips, etc. to their original locations.
To ensure assemblies are aligned,
insert all bolts and
leave the nuts loose until completion of final
assembly
. Use lock washers or flat washers where
called for. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly
to prevent misalignment, distortion, or binding. Tighten all
bolts and nuts to the recommended torques shown on
. Tighten all u-bolt legs evenly.
IMPORTANT
Check all bolt lengths, nut sizes, etc., from the parts
book before assembly. Different models of the 2512
Series Rigid & Folding Zone Commander use
different size bolts.
Specific Dangers and Warnings
DANGER
DANGER
DANGER
WARNING
In the event a shank trips and does not release,
do not attempt to release the shank. Contact your
Landoll dealer for further instructions. A tripped
shank can release suddenly and cause serious
injury or death.
Coulter blades are extremely sharp. use extreme
care when working on or near coulter blades. Do
not allow coulters to roll over or fall on any part
of body. Do not allow wrenches to slip when
working near coulter blades. Never push
wrenches towards coulter blades. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges may result in
serious personal injury or death.
To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts.
2. Lower equipment to the ground while servicing or
when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the
system of all air may cause the machine to
operate improperly.
Summary of Contents for Brillion 2512 Zone Commander
