Landoll 9650, Operator'S Manual

Page: 142 / 182

3-36 F-605-1022
TABLE OF CONTENTS
Shank Installation
See Figure 2-2 through 2-5 for shank placement
dimensions. Verify that all shank clamps and extensions
are properly installed.
1. Install shanks in clamps See Figure 3-27 .
a. Spring clamp assembly - Install shank in clamp
using 5/8 X 1-3/4 round head square neck screw
and flange lock nut provided.
b. Install shank clamp, 1/2 x 3-1/4 hex head cap
screw, and lock nut across bottom of shank
clamp weldment.
c. S-tine clamp assembly - Install shank in S-tine
spring using 5/8 X 2-1/4 bolt and flange lock nut
provided.
2. Install sweep on shank with 7/16 X 1-1/2 plow bolt,
washers, and nuts provided. Note that the flat washer
is only used in the lower slotted sweep hole.
NOTE
Spring shank assemblies with frame extensions (front
bar) are mounted reversed for narrower shipment. These
shanks must be removed and turned forward for proper
operation.
See Figure 2-2 through 2-5 for proper
placement. and See Figure 3-27 for proper u-b0lt and
shank extension. After shanks have been reversed, verify
that springs have been set to the proper tension. Adjust
the spring until there is 1/8” gap between the top of the
mount and locking jam nut on top of the spring
See
Figure 3-26 Lock the jam nut against the top of the
spring, not the top of the mount.
NOTE
Refer to “Spring Shank” on page 4-10 for proper
adjustment and operation of spring shanks.
Figure 3-26: Spring Adjustment
1/8”
5/8 X 3 BOLT
SPRING PLATE
5/8 JAM NUT
SPRING
ASSEMBLY
SHANK CLAMP
WELDMENT
MAIN PIVOT
BOLT