Landoll 9650, Operator'S Manual

Page: 148 / 182

3-42 F-605-1022
TABLE OF CONTENTS
5 Row Spike Harrow Installation
See Figure 2-31 through 2-42 for 5 Row Spike Harrow
placement dimensions.
1. Attach spike harrow arm assemblies and spike
harrow arm clamp to rear frame using 3/4-10 x 9 hex
head cap screws and hex lock nuts
See Figure 3-31 .
NOTE
Location of bar clamps with tabs, and position
harrow arm assemblies in the correct locations.
2. Attach pull chain bracket to spike harrow arm clamp
using 3/4-10 x 5 hex head cap screws and hex lock
nuts.
3. Refer to Note: spike bar alignment See Figure 3-31
for proper alignment of spike bar assemblies. Be sure
they are aligned properly on both right and left side of
each section.
4. Attach spike bars to spike harrow arm assemblies per
placement drawings using bar clamps, bar clamp
plates 1/2-13 x 3 hex head cap screws, or bar clamps
w/ tabs, 1/2-13 x 1-1/4 hex head cap screws, and hex
lock nuts.
5. Refer to the “5 Row Spike Harrow Adjustments” in
Operation and Maintenance section for spike bar
alignment
See Figure 4-15 .
NOTE
See Figure 2-31 through 2-42 for 5 Row Spike Harrow
placement dimensions of spike harrow arms, spike
bars, and usage of bar clamps or bar clamps w/ tabs.
NOTE
T he harrow arms with the catch tray hooks are used
on the outer wings with the catch tray hooks toward
the outside of the machine and the catch trays
toward the center of the machine
See Figure 2-31
through 2-42 and See Figure 3-31 for proper
placement.