Landoll 9650, Operator'S Manual

Page: 112 / 182

3-6 F-605-1022
TABLE OF CONTENTS
Hitch and Leveling Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
WARNING
1. Slide hitch extension weldment under center frame
and attach hitch extension to the center frame ears on
the front of the center frame using hitch pins, machine
bushings, and 5/16 x 2-1/2 spring pins
See
Figure 3-3 .
2. Attach hitch extension to the center frame using 5/8 x
3-11/16 x 5-1/2 u-bolts and 5/8 lock nuts.
3. Connect hitch to the front of the hitch extension using
hitch pin, machine bushings, and 5/16 x 2-1/2 spring
pin.
4. Install the tongue jack in the forward mounting tube
and rotate to parking position to support the front of
the hitch.
5. Insert a 3/4 x 7 hex head cap screw into the hose
holder tube on the hitch from the bottom side so the
threads point upward. Hold in place with a 3/4
prevailing torque flange nut with the flange pointing
upward as well. Do not tighten this cap screw, so the
hose holder bracket may pivot freely in this joint.
6. Slide the hose holder bracket over the 3/8 x 7 bolt and
secure with another 3/4 prevailing torque flange nut.
7. Install a 3/8-16 x 3-1/2 all thread in the front of the
hose holder bracket and secure with a 3/8-16 hex nut.
8. Slide the hose holder clamp over the 3/8 x 3-1/2 all
thread and loosely start the wing nut on top of the
clamp. Hydraulic hoses will be routed through the
clamp after assembly.
NOTE
The clamp has two sides, so that extend hoses can
be located on one side and retract hoses can be
located on the other side for reference.
9. Loosely install 3/8 x 2-1/2 bolt, 3/8 flat washer, hose
clamps and 3/8 lock nut until the hoses are routed
through them.
10. Attach the store-a-way harness to the bottom side of
hose holder bracket using 1/4 x 1 bolts and 1/4 lock
nuts.
Do not attempt to lift heavy parts (such as the
pull hitch) manually. Use a hoist or a fork lift to
move these parts into position.