Landoll 2130, Operator'S Manual

Page: 47 / 83

3-10 HYDRAULIC INSTALLATION
Note: Refer to Figures 3-10 through 3-15 for
coulter lift, wheel lift, and fold hydraulic dia-
grams.
3-10.1 On all models, install the 16 port mani-
fold to the manifold bracket on the front cen-
ter frame tube using 1/2-13 x 3-1/2 hex head
cap screws and hex lock nuts
(See Figure
3-8) .
3-10.2 On all models, install 8 port manifold to
the manifold bracket on the center frame
weldment near the right side of the rear fold
anchor using 1/2-13 x 3-1/2 hex head cap
screws and hex lock nuts
(See Figure 3-8) .
3-10.3 On 2130-21, 2130-23, and 2130-25
models, install second 8 port manifold to the
manifold
bracket on the center frame
weldment near the right side of the front fold
anchor using 1/2-13 x 3-1/2 hex head cap
screws and hex lock nuts
(See Figure 3-8) .
3-10.4 Install 90
o
adapter in port N in the rear
of the manifold.
3-10.5 Install straight adapters in any manifold
port that has a hose connection.
3-10.6 Verify that limit valve is installed below
the depth stop bracket welded to the frame.
If not, refer to
Section 3-3.4 .
3-10.7 Install coulter lift, wheel lift, and fold
system hoses per Figures 3-10 through
3-15.
3-10.8 Hold each system of hoses in place us-
ing 3/8-16 x 4 hex head cap screw, hose
clamps, and hex lock nut (See Figure 3-9) .
3-10.9 Install plugs in any remaining open
manifold or valve ports.
3-10.10 Install hose wraps around system
hoses per hose identification decal near
hose couplers, putting both hoses inside
wrap
(See Figure 3-9).
3-17
3/8-16 X 4 HEX
HEAD CAP SCREW
HOSE CLAMPS
3/8-16 HEX LOCK NUT
2130 hitch hose clamps
Figure 3-9 Hitch Hose Clamps and Color Designation