17
Assembly
Assembly step 1
Diagram A
17
6
5
H
H
1
•
Place the smoking chamber (2) on the ground
with the open side facinging to side (see Diagram
A). Fasten a long leg(5) and a short leg(6)to the
smoke chamber by removing the plastic cover
from the stud bolts of the legs. Place the bolts in
the holes that are closest to the open side of the
smoking chamber; note that the Anchor the legs
in their place by attaching two M6 washers and
two M6 nuts (H) on the ends of the bolts from the
inside of the smoking chamber. DO NOT TIGHTEN
BOLTS.
•
Insert the wire shelf frame (17) into the holes of
the now attached legs.
•
Fasten the remaining short leg (6) and long
leg(5) to the smoke chamber by attaching the
legs on the wire shelf frame and swinging the
legs upward into their proper position. Ensure
that the axle bolts on the legs are pointing out.
Insert the stud bolts on the ends of the legs into
the smoking chamber. Fasten the legs in their
place by attaching two M6 washers and two M6
nuts on the ends of the bolts from the inside of
the smoking chamber.
DO NOT TIGHTEN BOLTS
.
Attention:
Due to the weight of this device ensure that you have a second person assist you. Do
NOT
assemble this device
alone. Wear gloves when you grasp parts that could have sharp edges.
Please read these instructions completely through before you start assembling this product. Comply with all
instructions contained in this document. Read all instructions through and carefully consider these instructions
before using the device.
Warning:
DANGER DUE TO CARBON MONOXIDE! Only use in a well-ventilated environment. CARBON MONOXIDE is released
when burning charcoal.
CARBON MONOXIDE is a toxic, odourless gas. CARBON MONOXIDE can be fatal if inhaled. Do
NOT
use the device
in rooms, tents, or vehicles.
