Landice L Series, Diagnostic And Service Manual

Page: 24 / 127

24
ASSEMBLY INSTRUCTIONS
STEP 5 Install side cover screw
Align the side frame cover beneath the end
cap and install the Phillips head screw.
Tighten the Phillips head screw until side
cover aligns with endcap.
STEP 6 Check drive belt tension
Check the tension on the drive belt by placing
the drive belt between your thumb and
forefinger and twisting.
The proper twist is 45
°
. If the belt needs to be
adjusted use a 7/16” socket and turn the bolt
underneath the motor pan attached to the
hook screw.
STEP 7 Route the wire harness
HOME:
Route the wire harness
UNDERNEATH
the
elevation motor and secure with tie-wrap
provided. Plug connector into circuit board
until it snaps into place.
COMMERCIAL:
Route the wire harness
AROUND
the
elevation motor and secure with tie-wrap
provided. Plug connector into circuit board
until it snaps into place.
STEP 8 Install motor cover
Attach motor cover with Phillips head screws
provided. Plug treadmill into a dedicated 15A
outlet.