CB01A.C01
Service instructions, flowmaker type POPL-I
Page 2/8
Landia Inc.
Issued on: 01 March 1997
Cary, NC 27513
Rev. date: 24 October 2018
Executed by: AJ/CML
Accepted by: SL/KT
IMPORTANT !
The flowmaker must
ALWAYS
be fully below liquid level during
operation.
IMPORTANT !
Prior to hoisting the flowmaker for service/repair
IT IS IMPERATIVE
that the electrical connection of the flowmaker is switched off or locked
out. Prior to service/repair the flowmaker should be cleaned thoroughly.
IMPORTANT !
When the flowmaker is hoisted or lowered, its cable and chain
are always
to be placed outside the work area.
IMPORTANT !
For service/repair of flowmakers mounted in well/tank with explosion
danger/toxic gases we refer to the ANSI regulations, e.g. concerning the
toxic hydrogen sulphide.
Service/repair:
To maintain a high operating safety and a long service life without unnecessary and expensive repair it is
important from the beginning to execute regular and preventive service. Maintenance should be executed
according to the intervals stated in the manual. Always follow the instruction carefully and only apply the parts
described by Landia in the spare parts list. We can refer to a service partner in your territory.
Please note
If spare parts not identical to the ones recommended are used at service/repair, the guarantee from Landia will be
voided. Spare parts can be ordered at Landia or your local distributor.
For major repairs at a special workshop please contact:
Head office:
US subsidiary:
LANDIA A/S
Landia Inc
Industrivej 2
111 Triangle Trade Drive
DK-6940 Lem St.
Cary, NC 27513
Tel.: + 45 97 341244
Phone: 919 466 0603
Fax: + 45 97 341698
Fax: 919 460 1666
E-mail: [email protected]
e-mail: [email protected]
www.landia.dk
Landia is represented by local distributors worldwide, please call for further information.
