4
WATER JET SYSTEM
INSTRUCTION MANUAL AND PARTS LIST
WATER JET SYSTEM Manual • #96-617 • Rev 12/03
NOTE: For ideal cleaning, the Water Jet must be
attached to a minimum 4 gpm at 3,000 psi pres-
sure washer.
5. Adjust the rotary spraybar to its highest position.
Loosen the adjustment knob (item #7) on the front
of the Water Jet dome and slide the knob upward to
raise the rotary spraybar to its highest position and
tighten.
6. Turn on water supply and start pressure washer.
NOTE: It is always important to test in a small
area for the correct height adjustment needed
so surface being cleaned won’t be damaged.
7. Pull the trigger for water to start cleaning surface.
NOTE: Never stop moving the Water Jet while
trigger is engaged and surface is being sprayed
or damage to surface could occur.
8. For use of the spray gun in isolated cleaning, check
the nozzle size (item 24). The Water Jet is shipped
with a #6 nozzle; if your pressure washer requires a
larger nozzle, you will need to use the nozzle from
your pressure washer.
NOTE: For use of the spray gun, be aware that
the Water Jet comes with a #6 nozzle and two #3
nozzles on the rotary swivel.
HIGH PRESSURE
SWIVEL INFORMATION
The Water Jet high pressure swivel will “weep” water from
underneath the dome cover (item 1). This weeping is
normal for this swivel and will weep even more with hot
water than with cold. The swivel uses water to lubricate
its floating seal face to keep wear down to a minimum.
Also the high pressure swivel is equipped with a grease
fitting and should be greased at least once every three
months. A good quality ball bearing grease is recom-
mended. DO NOT OVER GREASE THE BEARING!
The Warranty for this high pressure swivel is one year
from date of purchase.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
