13
Operations
Rinsing
It will take a few seconds for the
detergent to clear. Apply safety
latch to spray gun. Remove black
soap nozzle from the quick coupler.
Select and install the desired high
pressure nozzle.
NOTE:
You can
also stop detergent from flowing by
simply removing detergent siphon
tube from bo
Shutting Down And Clean-
up
STEP 1:
Remove detergent suction
tube from container and insert into
one (1) gallon of fresh water. Pull
trigger on spray gun and siphon
water for one minute.
STEP 2:
Turn HS burner switch off
and continue spraying water,
allowing the water to cool.
After water has cooled to less than
100°, turn the attached pressure
washer off.
STEP 3:
Turn water off.
STEP 4:
Open the spray gun to
relieve remaining pressure.
Landa HS Operator’s Manual 8.913-943.0 - P
Burner
Switch
Storage
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The heating coil in this machine is
susceptible to permanent damage if frozen.
FREEZE DAMAGE IS NOT COVERED BY
WARRANTY.
ATTENTION: Toujours entreposer la laveuse à
pression dans un endroit où la température ne sera
pas inférieure à 0 °C (32 °F). La pompe sur cette
machine est susceptible de subir des dommages si
elle est exposée au gel. LES DOMMAGES DUS AU
GEL NE SONT PAS COUVERTS PAR LA
GARANTIE.
1. Stop the pressure washer, squeeze spray gun
trigger to release pressure.
2. Use compressed air at the inlet hose to blow water
out discharge nipple.
3. Store the machine and accessories in a room
which does not reach freezing temperatures.
CAUTION: Failure to follow the above
directions will result in damage to your
pressure washer.
ATTENTION: Le non-respect des direc-
tives ci-dessus entraînera des
dommages à la laveuse à pression.
After Extended Storage
CAUTION: Prior to restarting, thaw out any
possible ice from pressure washer hoses, spray
gun or wand.
ATTENTION: Avant de redémarrer, faire fondre la
glace se trouvant sur les boyaux, le pistolet
pulvérisateur ou la lance de la laveuse à pression.
