Section 1: Assembly & Set-up
WB10 & WB15 Weight Box 335-064M
6/1/22
10
Unhook WB10
Refer to Figure 1-2 on page 9:
DANGER
!
To avoid serious injury or death:
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
•
Park Weight Box on a solid, level surface that will not give
way when wet or for any other reason. Make sure the box is
stable and can not fall over.
on page 16 when parking
the Weight Box for long periods or at the end of the
season.
2. Park tractor with Weight Box on a flat, level, solid
surface.
3. Lower the box down until it is resting on the ground.
4. If unhooking from a Quick Hitch, follow instructions in
the Quick Hitch Operator’s Manual. Otherwise,
continue with step 5.
5. Shut tractor down according to
6. Remove hairpin cotter (#4) and clevis pin (#3).
7.
Store top center 3-point link in tractor holder.
8. Reinstall clevis pin (#3) and hairpin cotter (#4) in the
Weight Box center clevis for safe keeping.
9. Remove linchpins (#2).
10. Move lower 3-point arms off of hitch pins (#1).
Replace linchpins (#2) in the hitch pins for safe
keeping or store in a secure location for reuse.
11. Return to the tractor and drive slowly away making
sure tractor and lower 3-point arms are clear while
pulling away.
