Section 1: Assembly & Set-up
WB10 & WB15 Weight Box 335-064M
6/1/22
8
Tractor Requirements
Tractor horsepower should be within the range noted
below. Tractors outside the horsepower range must not
be used.
WB10
Horsepower . . . . . . . . . . . . . . . . Up to 47 hp (35 kW)
3-Point Hitch . . . . . . . . . . . . . . . . . . . . . . . . . . . Cat. I
Tractor Weight . . . . . . . . . . . . . . See Warnings Below
WB15
Horsepower . . . . . . . . . . 24 hp to 110 hp (18 - 82kW)
3-Point Hitch . . . . . . . . . . . . . . . . . . . . . . Cat. I/Cat. 2
Tractor Weight . . . . . . . . . . . . . . See Warnings Below
WARNING
!
To prevent serious injury or death:
Consult your power machine Operator’s Manual for
operating capacity, lifting capacity, and operating
specifications. Exceeding rated capacities and specifications
can result in loss of control, roll-over or other serious hazard.
Common Bolt Torque Values
Refer to
“Torque Values Chart”
on page 22 to determine
correct torque values when tightening hardware.
Before You Start
This Weight Box is shipped fully assembled from the
factory. Some preparation will be necessary to attach the
implement to the customer’s tractor. Make sure the
intended tractor conforms to
before
attaching the Weight Box to a tractor. To make the job
safer, have all needed parts and equipment readily at
hand.
Pre-Assembly Checklist
Check
Page
Have a forklift or hoist with properly sized chains and
safety stands on hand capable of lifting and supporting
the equipment.
Have a minimum of two people available during
assembly and Set-up.
Double check to make sure all hardware is
installed in the correct location. Refer to the
Parts Manual if unsure.
Parts
Manual
335-064P
Make sure bolts and nuts are tight.
Operator’s
Manual
Make sure all safety labels are correctly
located and legible. Replace if damaged.
Important
Safety
Information
Section 1: Assembly & Set-up
