Land Pride REAR BLADES RBT55120, Operator'S Manual

Page: 14 / 34

Section 1: Assembly & Set-Up
Table of Contents
RBT55120 Rear Blade 301-172M 11/27/18
10
Blade Offset Cylinder
Refer to Figure 2-1:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
Assemble hydraulic hoses to hydraulic cylinder before
attaching hydraulic cylinder to the Rear Blade.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two straight fittings (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 116" long hydraulic hoses (#5) into
straight fittings (#4) and tighten.
3. Thread adapter fittings (#6) onto opposite end of
hydraulic hoses and tighten. (Customer to supply
quick disconnect hydraulic couplings.)
4. Attach hydraulic cylinder to lugs located on left side of
3-Way Rear Blade with clevis pins (#2). Make sure
hydraulic ports are positioned on top and cylinder
base is positioned to the front as shown.
5. Secure clevis pins with hair pin cotters (#1).
6. Route hoses through hose bracket located on right
side of front hitch. Connect hoses to tractor's
hydraulic system.
Hydraulic Blade Offsetting
Figure 2-1
IMPORTANT: Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
25502
Customer to supply Quick
Disconnect Couplings.
Blade Angling Cylinder (Option)
Refer to Figure 2-2:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two straight fittings (#4) into cylinder
ports as shown. Tighten as needed.
2. Screw 116" long hydraulic hoses (#5) into
straight fittings (#4) and tighten.
3. Thread adapter fittings (#6) onto opposite end of
hydraulic hoses and tighten. (Customer to supply
quick disconnect hydraulic couplings.)
4. Attach hydraulic cylinder to lugs on right side of frame
with clevis pins (#1). Make sure hydraulic ports are
positioned on top and cylinder base is positioned to
the front as shown.
5. Secure clevis pins with hair pin cotters (#2).
6. Route hoses through hose bracket located on right
side of front hitch. Connect hoses to tractor's
hydraulic system.
Hydraulic Blade Angling
Figure 2-2
IMPORTANT: Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
25503
Customer to supply Quick
Disconnect Couplings.