17
Section 1: Assembly & Set-Up
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
8/20/21
RCF(M)3610 Tailwheels (3-Point)
These instructions apply only to 10' models with the
optional rear axle hydraulic lift. If hydraulics are not
included with your cutter, skip to
on page 15.
Refer to Figure 1-8:
1. There are several cylinder mounting lugs (#3) that
can be installed on axle (#1). Refer to
NOTES IN
BOLD
in Figure 1-8 to make sure your cutter is
equipped with the correct mounting lug and that the
notch in the lug is located on the axle properly. See
your nearest Land Pride dealer if it is not correct.
2. Attach left and right-hand tailwheel arms (#2) to axle
tube (#1) with 5/8"-11 U-bolts (#5) and hex flange
locknuts (#4). Do not tighten locknuts.
3. Adjust tailwheel arms to customer preference and
then tighten locknuts (#4) to the correct torque. When
completed, the tailwheel arms should be equal
distance from center line of hydraulic lift cylinder.
on page 19.
NOTE:
If preferred, rear guards may be assembled
before the tailwheels. See
“Assembly of Optional
Equipment”
on page 36 for rear guard instructions.
RCF(M)3610 3-Point Tailwheel Assembles
Figure 1-8
35003
RCF(M)3610 Model With 15" Tailwheel Assembly
35025
(M)
RCF(M)3610 Model With 21" Tailwheel Assembly
