Section 4: Maintenance & Lubrication
OFM2660, OFM2672 & OFM2678 Offset Flail Mowers 333-142M
3/1/21
52
IMPORTANT:
Use oils and lubricants with
characteristics identical to those specified.
IMPORTANT:
Observe correct filling quantities.
Regularly check the levels. A level that is too low or
too high can cause damage to the implement.
NOTE:
Before lubricating, thoroughly clean the
parts involved, especially zerks, to prevent any
impurities from mixing with the lubricant.
30
Hrs
Multi-purpose
spray lube
Multi-purpose
grease lube
Multi-purpose
oil lube
Intervals in hours at which
lubrication is required
Lubrication
Legend
Lubrication Schedule and Points
76075
76076
76076
30
Hours
Front, Lateral Pivot Pins
2 - Zerks
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease emerges
Back, Lateral Pivot Pins
2 - Zerks
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease emerges
30
Hours
Incline Cylinder Clevis Pin
1 - Zerk
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease emerges
30
Hours
Lubricate all required points of the implement. Usually,
grease points are situated near joints, sliding surfaces
and bearings. For this reason, please check the entire
implement for grease points.
The intervals indicated are for moderate use of the
implement. Shorter service intervals are necessary in the
case of more intensive usage (e.g. use by contractors).
Shorter service intervals may also be necessary in
extreme operating conditions, such as when working in a
very dusty environment.
