LANCOM OAP
-
54
-
1 Wireless – LANCOM OAC
-
54
-
1 Wireless
Chapter 2: Installation
16
EN
2.3.1
LEDs of LANCOM OAP-54-1 Wireless and LANCOM OAC-54-1
Wireless
The front panel of the unit feature a series of light emitting diodes (LEDs) that
provide information on the status of the device.
���
Power
This LED provides information on the device's operating state. After being
switched on, it blinks green during the self-test. The LED then shines con-
stantly to indicate operational readiness, unless an error is detected as indi-
cated by a code blinked in red.
The power LED blinks alternately in green until a configuration pass-
word has been set. Without a configuration password, the configura-
tion data in the LANCOM are unprotected. Normally you would set a
configuration password during the basic configuration (instructions in
the following chapter). Information about setting a configuration
password at a later time is available in the section 'The Security
Wizard'.
���
WLAN Link
Provides information about the WLAN connections via the internal WLAN
module.
쐃 쐇 쐋
Off
Device switched off
Green
On (perma-
nently)
Device operational
Red
Blinking
The device is locked because location verification was
not successful
