LANCOM OAP
-
54
-
1 Wireless – LANCOM OAC
-
54
-
1 Wireless
Chapter 2: Installation
18
EN
쐏
Goretex membrane for compensation of fluctuations in pressure and
humidity.
쐄
Main connector for external antennas. Additional AirLancer antennas are
connected to the Main connectors if necessary. The integrated RF switch
automatically changes to the usage of an external antenna.
쐂
10/100Base-Tx for connection to the LAN. Both 10 Mbit or 100 Mbit con-
nections are supported. The available transfer rate is detected automati-
cally (autosensing). The LAN connection features an automatic MDI/MDIX
detector enabling the use of cross-over cables.
The LAN connector on the LANCOM OAP/OAC-54-1 Wireless supports
Power over Ethernet (PoE).
The reset function
Via the serial interface the device can either be bootet (restarted) or reset (to
the factory settings).
Unsrew the fitting of the “COM/Reset” interface at the bottom of the device.
Insert the reset plug to the serial interface. Via this plug, two connectors of
the interface are bridged, which starts the reset process.
Press the reset plug briefly to re-start the device. Pressing the button for 5
seconds or longer restarts the device and resets the configuration to its factory
settings. All LEDs on the device light up continuously. Once the switch is
released the device will restart with the restored factory settings.
After resetting, the device starts completely unconfigured and
all
settings are lost. If possible be sure to backup the current device
configuration
before
resetting.
After resetting, the LANCOM Access Point returns to managed mode,
in which case the configuration cannot be directly accessed via the
WLAN interface!
