9
FIGURE 9 - PORTION CONTROL,
CUP BUTTONS
FIGURE 10 - PORTION CONTROL,
CUP BUTTONS,WITH WATER
6.3 SETTING THE RATIO/CARBONATION
A. Connect the programmer to the Valve.
B. Press the
[Read Mem]
button.
C. Press the
[Ratio +]
or the
[Ratio -]
key until the desired ratio is displayed.
D. Verify drink type. Press
[Carb Toggle]
to select
[C]
for carbonated or
[n]
for non-carbonated.
E. Press the
[Enter]
button to program the valve with the setting on the display
F. Verify Ratio by pressing
[Read Mem]
.
G. Disconnect the programmer.
7.0 PORTION CONTROL PROGRAMMING PROCEDURES
The following procedures describe the operation and programming of portion control ID panels for the
Volumetric Valve.
7.1 OPERATION
A. Cup buttons are Small, Medium, Large, Extra-Large.
B. Press and release the desired cup size. Valve will fill cup as programmed (See below).
C. Pour/Cancel Button
1. Push and release to cancel or stop valve dispensing.
2. Push and hold for continuous pour.
D. Water Button
1. Push and hold for continuous water pour.
2. Valve will dispense carbonated or non-carbonated water, depending on its location on the
dispenser.
7.2 TEACH AND LEARN PORTION CONTROL PROGRAMMING
In this mode, the valve will record (learn) the steps to fill each cup size, including the top off
delay time. When activated, the valve dispenses the appropriate drink volume. If a top off has been
entered, the valve will pause for the programmed length of time. Finally, the valve will dispense the
correct top off amount.
A. Initial Install Procedure
1. Simultaneously, press and hold the small cup button and the extra-large cup button
switches on the portion control until the LED light in center of module starts blinking, then
release switches. The blinking LED indicates that the set mode is active.
2. Put desired amount of ice in cup, place cup under valve and push selected size button
(small, medium, large, or extra-large). Hold button in until cup fills to desired portion, then
release button.
3. Top off: If a top off is not needed, go to Step 4. Wait for foam to settle, then actuate button
again to top off.
NOTE:
Only one (1) top off is allowed.
4. Repeat steps 2 and 3 for other drink sizes. Go to Step 5 to exit program mode.
5. Press and release pour/stop button to return the portion control to the operational mode.
Blinking LED light will go out.
6. Repeat steps 1 through 5 for remaining valves.
Pour/Stop
Small
Medium
Large
Extra-Large
Cup Button
Cup Button
Cup Button
Cup Button
Cup Button
water
Water
Pour/Stop
Small
Medium
Large
Extra-Large
Cup Button
Cup Button
Cup Button
Cup Button
Cup Button
Button
7.3 TO CHANGE DISPENSE SIZE
Use procedures in the Initial Install Procedure discussed above; it is not necessary to reprogram
every size.