3
INSTALLATION
Unpack the Dispenser
1. Cut band and remove.
2. Remove unit, with plywood shipping base, from packaging.
3. Remove plywood shipping base from unit.
If unit is to be transported, it is advisable to leave the
unit secured to the plywood shipping base.
NOTE
Inspect unit for concealed damage. If evident, notify
delivering carrier and file a claim against the same.
NOTE
4. If leg kit has been provided, assembly legs to unit by tilting
unit to one side.
Drain Spider:
The drain spider is located to the left side near the front of the
bin. The coldplate has a cavity designed to hold the drain spider.
During shipment or installation, the drain spider may become
dislodged from its original position. Prior to installing the
dispenser, ensure the drain spider is in the correct position. This
will prevent drain clog issues. Inspect the lower bin area to
ensure the drain spider is secure in the coldplate cutout. If the
drain spider is not in place, locate the drain spider and reinstall in
the cavity where drain line exists.
Selecting/Preparing Counter Location
1. Connecting lines can be run through the front of the unit and
can extend down through a counter cutout.
2. Select a level, well ventilated, accessible location away from
direct sunlight (avoid) or overhead lighting, within five (5) feet
(1.5 m) of a drain, and a water supply that meets the
requirements shown in the Specifications section found on
previous page.
3. Select a location for the syrup pumps, CO
2
tank, syrup
containers, and water filter (recommended).
4. The selected location should be able to support the weight of
the unit with the ice after counter cut out is made (if
applicable).
Leveling the Dispenser:
In order to facilitate proper dispenser drainage, ensure that the
dispenser is level, front to back and side to side. Place a level on
the top of the rear edge of the dispenser. The bubble must settle
between the level lines. Repeat this procedure for the remaining
three sides. Level unit if necessary. For optimum performance
place the unit at a 0° tilt.
Your Service Agent:
Service Agent Telephone Number:
Serial Number:
Model Number:
This manual was developed by the Lancer Corporation as a reference for the owner/operator and installer of this
dispenser. Please read this guide before installation and operation of this dispenser. If service is required please call your
Lancer Service Agent or Lancer Customer Service. Always have your model and serial number available when you call.
READ THIS MANUAL
The installation, and relocation if necessary, must
be carried out by qualified personnel with up-to-date
knowledge and practical experience, in accordance with
current regulations.
NOTE
NSF listed units must be sealed to the counter or have
four (4) inch legs installed.
NOTE
Installation of Unit
2. Remove Top Cover.
3. Remove the two (2) valves from ice bin.
4. Install valves onto mounting blocks at front of dispenser.
Push wire retainer down. This will lock valve to mounting
block.
1. The dispenser is designed to be installed either
permanently to counter or placed on a counter using the four
(4) inch legs (included in the Lancer kit, PN 82-1704)
