16
Dispenser Setup
1. Turn on water source.
2. Open the pressure relief valve located on the front of the
unit by flipping up the valve cap lever. Hold open until water
flows from the relief valve; then, close (flip down) the relief
valve.
Never energize the machine if there is any trace
of damage. Contact Lancer Customer Service
for assistance. The dispenser must be properly
electrically grounded to avoid serious injury or fatal
electrical shock. The power cord has a three-prong
grounded plug. If a three-hole grounded electrical
outlet is not available, use an approved method to
ground the unit. Follow all local electrical codes when
making connections. Each dispenser must have a
separate electrical circuit. Do not use extension cords.
Do not connect multiple electrical devices on the
same outlet.
F
WARNING
3. Verify all Bag-In-Box contains syrup and check all
connections for leaks.
4. Place enough ice in the ice bin to fill approximately 1/2 of
the bin before connecting the unit.
5. Connect unit power cord to grounded electrical outlet.
6. Turn on the power to the dispenser by pressing the circuit
breaker on the right side of the unit’s electrical box and
turning the 3-way key switch (located on the right side of the
unit) to the vertical position.
A
A. Circuit breaker
N’alimentez jamais la machine s’il y a une trace quel
conque de dommage. Contactez le service à la clientèle
de Lancer pour obtenir de l’aide. Assurez-vous que
la distributrice est reliée à la terre pour éviter des
blessures graves ou des décharges électriques. Le
cordon d’alimentation comporte une fiche de terre à trois
broches. Si une prise électrique à trois trous n’est pas
disponible, utilisez une méthode approuvée pour assurer
la mise à la terre de l’appareil. Les raccordements
électriques doivent être conformes au code électrique
local. Chaque distributrice doit être branchée dans
un circuit électrique dédié. N’utilisez pas de rallonge
électrique. Ne branchez pas plusieurs appareils sur la
même prise de courant.
!
AVERTISSEMENT
7. Test the ice dispense feature by ensuring that the ice auger
runs when the ice lever is pressed.
8. If necessary, turn on the screen by pressing the circuit
breaker on the unit’s electrical box.
9. Once the screen has booted up, the service menu for drink
setup must be accessed.
Access Service Menu
1. Access the
Service Menu
by turning the key switch
clockwise to the third position.
2. A keypad will appear, enter the designated pin number to
access the service menu.
3. For technician access to service menu enter the
technician’s pin number:
4433.
Sleep Position
On Position
Service Position
