Lamona LAM9550, User Instructions And Installation

Page: 26 / 44

26
www.howdens.com
Fan time lag
The fan time lag is used after cooker in order to remove
cooking odours. The filter is also dried in the fan.
Setting the fan time lag
1.
Select the fan power setting.
2. Then use the Plus key or the Minus key of the timer
to set the required time for the fan time lag.
Left position: Hours
Centre position: Every 10 minutes
Right position: Every minute
3. After a few seconds your input will be assumed and the
procedure will have commenced.
The timer symbol of the fan lights up.
4. The fan will be switched OFF when the time has lapsed.
If a cooking zone is switched ON, the timer does not run
until the cooking zone has been switched OFF. If the hob is
switched OFF using the ON/OFF key during fan after run-
time, the timer runs down to a low fan level.
After run time
The fan motor should continue operating for another 10-20
minutes every time the hob has been used for cooking.
When the fan is switched OFF after having been in
operation, an automatic after run time at a low setting will
follow.
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air filter, please always allow for
a stop delay time of 10 - 60 minutes in order to optimally
remove cooking odours.
When the fan is switched ON again, in rare cases the
odour molecules present in the filter may be combined
with steam so that they are detected again. These
remaining odours will disappear when the fan continues to
operate.
Important: When the convection air mode is in operation,
ventilation must be sufficient in order for the air humidity to
be removed.
Replacement of the filter
If an existing carbon filter must be cleaned or replaced,
this is indicated in the fan display by a or .
When the fan is switched ON, the display for a cooking
process is deleted.
1. To reset the display, the fan display must be pressed
simultaneously for approx. 3 seconds.
If no carbon filter is used, the display indication must also
be reset.
3. Operating the hob hood
(continued)
2.
3.
1.
4.
Press for 3 seconds
2.
1.
Change the carbon filter.
Clean the grease filter.
or
Press for 3 seconds
2.
1.