11
Exclusive to Howdens
3. Operating the hob hood
(continued)
Pan recognition limits
Cooking zone
diameter (mm)
Recommended minimal
diameter pan base
(mm)
160
90
200
110
210 x 190
110
The base of pots and pans must be of a
certain diameter; if it is not, the induction heat
will not be switched ON. Always place pots
and pans in the middle of a cooking zone in
order to achieve the best efficiency.
Important:
The minimum diameter required to
activate the pan recognition device may vary
according to the type of pot or pan used!
Operation time limit
The induction hob has an automatic time limit
function.
The duration of continuous use of each
cooking zone depends on the power level
selected (see chart).
This requires that the setting of a respective
cooking zone is not adjusted during use. If the
operation time limit has been activated, the
cooking zone will switch OFF, a short signal will
sound and an will appear in the display.
The automatic switch-OFF function overrules
the operation time limit, i.e. the cooking zone
is only switched OFF when the period of time
of the automatic switch-off device has expired
(e.g. automatic switch-off after 99 minutes and
cooking level 9 is possible).
Operation time limit
Selected power level
Operation time limit in
minutes
120
1
516
2
402
3
318
4
258
5
210
6
138
7
138
8
108
9
90
P
10
Other functions
If two or more sensor keys are pressed at the
same time (e.g. when a pan is mistakenly
put onto a sensor key) no function will be
activated.
The symbol Er03 will blink and a time-limited
continuous signal will sound. After a few
seconds the appliance will switch OFF. Please
remove the item located in front of the sensor
keys.
To delete the symbol Er03 press the same key
or switch the hob OFF and ON.
Protection against overheating (induction)
If the hob is used at full power for a longer
period, it will not be possible to cool down the
electronics system as required at a high room
temperature.
In order to ensure that no excessive
temperatures occur in the electronics
system the power of the cooking zones may
be reduced automatically. Should E2 be
displayed frequently during normal use of the
hob and at normal room temperature, it is
likely that cooling is not sufficient.
This may occur if kitchen units have no
openings. The installation may have to be
checked (see the section on Ventilation).
Summary of Contents for LAM9550
Page 2: ...2 www howdens com...
Page 43: ...43 Exclusive to Howdens...
