During the catalytic cleaning the oven lamp
is on.
1.
Set the Cata cleaning function (refer to
"Oven functions"). The display shows
"Cata" and the duration of the cleaning
procedure (1 hour).
You cannot set the Duration, but you
can use the End function to delay the
start of the cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2.
Touch a sensor field or open the oven
door to stop the acoustic signal.
3.
Clean the bottom of the appliance with
a soft and moist sponge.
Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different models.
WARNING!
Be careful when
you remove the door from the
appliance. The door is heavy.
1.
Open the door fully.
2.
Fully lift up the clamping levers (A) on
the two door hinges.
A
A
3.
Close the door until it is at an angle of
approximately 45°.
45°
4.
Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
5.
Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
6.
Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
1
2
B
CAUTION!
Rough handling of
the glass, especially around the
edges of the front panel, can
cause the glass to break.
7.
Pull the door trim to the front to remove
it.
8.
Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
25
