If you touch or
while
you set the DURATION, the
appliance switches to the
setting of the END function.
6.
When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display. The
appliance deactivates.
7.
Touch a sensor field or open the oven
door to stop the acoustic signal.
8.
Deactivate the appliance.
Setting the END
1.
Activate the appliance and set an oven
function and temperature.
2.
Touch again and again until the
display shows .
flashes in the display.
3.
Use or to set the END and
or
to confirm. First you set the minutes
and then the hours.
When the set time ends, an acoustic signal
sounds for two minutes. symbol and the
time setting flash in the display. The
appliance deactivates.
4.
Touch a sensor field or open the oven
door to stop the acoustic signal.
5.
Deactivate the appliance.
Setting the MINUTE MINDER
Use the MINUTE MINDER to set a
countdown (maximum 23 h 59 min). This
function has no effect on the operation of
the oven. You can set the MINUTE MINDER
at any time and also when the appliance is
off.
1.
Touch .
and "00" flash in the display.
2.
Use or to set the MINUTE MINDER.
First you set the seconds, then the
minutes and the hours.
3.
Touch and at the same time to
reset the set time.
4.
Touch
or the MINUTE MINDER
starts automatically after five seconds.
When the set time ends, an acoustic signal
sounds for two minutes and 00:00 and
flash in the display.
5.
Touch a sensor field or open the oven
door to stop the acoustic signal.
Setting the Time delay function
The DURATION and END can be
used at the same time, if the appliance is to
be switched on and off automatically later.
In this case, first set the DURATION and
then the END function (refer to "Setting
the DURATION" and "Setting the END" ).
When the Time delay function is
activated, the display shows a
static symbol of the oven
function, with a dot and .
The dot shows which clock
function is on in the Clock /
residual heat display.
USING THE ACCESSORIES
WARNING!
Refer to Safety
chapters.
Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
12
